Table of Contents
Advertisement
Serial-number
information
Safety considerations
W A R N I N G
General Information
N O T E
Clean the cabinet using a damp cloth only.
Failure to ground the lightwave trigger receiver properly can result in
personal injury, as well as instrument damage.
Before turning on the lightwave trigger receiver, connect a three-wire
power cable with a standard IEC 320-C13 (CEE 22-V) inlet plug to the
lightwave receiver power receptacle. The power cable outlet plug
must be inserted into a power-line outlet socket that has a protective
Do not
earth-contact.
extension cable, power cable, or autotransformer without a protective
ground conductor.
If you are using an autotransformer, make sure its common terminal is
connected to the protective ground conductor of its power-source outlet
socket.
defeat the earth-grounding protection by using an
Advertisement
Table of Contents
