Operation; Switching On Your Unit; Control Panel; Adjusting The Temperature - Kenwood KIFF5017 Installation Instructions Manual

operation

switching on your unit

1. Connect the mains cable to the mains socket. The lights on the control panel will light up for 3
seconds and there will be a long beep.The default temperature for the unit is 5°C.
2. To ensure that the unit is cool enough to sufficiently chill your food, wait 24 hours before filling it
with food.
3. If you are concerned that your unit is not being kept
cold enough and wish to check the temperature,
you will need a special fridge/freezer thermometer.
These are available from most supermarkets
and hardware shops. Place the thermometer in
either the fridge or freezer compartment and leave
overnight. The correct temperature for the fridge compartment should be at the recommended
5°C or lower. The correct temperature for the freezer compartment should be -18°C or lower.

control panel

1. Press the Temp button to adjust
the temperature of the unit. The
corresponding indicator will light up
to display current setting.
2. Press Super Cool button to
activate Super Cool mode. The
unit's temperature will decrease
more rapidly than normal. The
Super Cool and 2°C indicators will
light up.
Super Cool mode will automatically
switch off after 3 hours.

adjusting the temperature

Press the Temp button to adjust the internal temperature of the unit. The corresponding indicator will
light up to display the current setting.

noises inside the unit!

You may notice that your unit makes some unusual noises. Most of these are perfectly normal, but
you should be aware of them!
These noises are caused by the circulation of the refrigerant liquid in the cooling system. It has
become more pronounced since the introduction of CFC free gases. This is not a fault and will
not affect the performance of your unit. This is the compressor motor working, as it pumps the
refrigerant around the system.
14
3. If abnormal conditions are
detected, the alarm indicator will
flash and a buzzer will sound.
Press the Alarm button to
deactivate.
Alarm will sound if the door is
left open for over 2 minutes.
Closing the door will deactivate
the alarm.
4. The unit can be switched on or
off by pressing this button.