Table of Contents
Advertisement
5. SPECIFICATION
Top
Setting item
menu
Power
After AC Power On
FAN failure detection
Power saving mode
Boot
Boot Priority Order
Exit
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Table 5-16 BIOS Setup menu list
Default value
Auto
Enabled
Disabled
1. USB FDD
2. SATA CD/DVD
3. USB CD
4. DRIVE1
5. DRIVE2
6. PCI SCSI
! 7. OPTION PORT
! 8. USB HDD
9. Internal Shell
-
5-14
( (3/3)
Note
Specifies the action when the power to the
equipment is turned on.
Power On : When the power is turned on, the
OS is started automatically.
Stay Off : When the power is turned on, the
system goes into the soft power off
mode.
Auto : If the OS was running the last time the
power was turned off, the OS starts as in
the case of Power On. If the OS was not
running the last time the power was
turned off, the system goes into the soft
power off mode as in the case of Stay
Off.
If the backup battery runs out or the battery is
not connected and the power is off, the setting
is the same as Stay Off.
For details, see "PRECAUTION 11.
PRECAUTIONS ABOUT THE BIOS
SETTINGS".
Specifies whether the until will detect a fan
failure when the power is turned on.
Do not change this setting.
Specifies whether to launch the CPU in the
power saving mode.
Do not change this setting.
Do not change this setting.
Configures the priority order of the devices
from which an OS is booted.
Saves the changes you made in the setup into
the SPI-ROM and reboots the system.
Discards the changes you made in the setup and
reboots the system with the configuration you
saved in the SPI-ROM last time.
Loads the BIOS default settings.
Default values are loaded but not saved in the
SPI-ROM. If you want to save the default
settings in the SPI-ROM, use "Exit Saving
Changes".
Advertisement
Table of Contents
