(2) Installing a main memory
The orientation of a main memory module on a connector is fixed. When you
install a main memory module, make sure the orientation is correct. Otherwise,
failure of the equipment may result.
Do not install main memory modules with different capacities on slot A2 and
slot B2. If you do, the modules may not be recognized.
[1] Follow the instructions in "6.3.3 Installing and removing the cover of the equipment" to
remove the cover of the equipment.
[2] Refer to the figure below and remove the SATA cables from the backboard connectors.
NOTICE
Figure 6-4 Removing the SATA cables
6-13
6. CHECKUP AND MAINTENANCE
Silk printing
SATA1
RAID
connector
connector
Note : When installing the SATA cables,
check the silk printing of the
cables and attach them to the
corresponding connectors.
SATA0
connector