Cleaning The Interface Fiber Jumper Sc/Apc Connector; Figure 9: Cleaning The Barrel Of The Optical Bulkhead Fitting; Figure 10: Cleaning The Sc/Apc Connector Tip - Motorola GX2 EA1000C Series User Manual

Installation and Setup

Figure 9: Cleaning the Barrel of the Optical Bulkhead Fitting

Cleaning the Interface Fiber Jumper SC/APC Connector

In addition to cleaning the optical bulkhead on the GX2-EA1000C*/*, it is also important
to clean the interface fiber jumper optical connector(s). This cleaning should be
performed before you insert the GX2-EA1000C*/* into the GX2-HSG*.
To clean the interface fiber jumper SC/APC connector(s):
1. Remove the protective boot from the end of the SC/APC connector.
2. Clean the tip gently with lint-free wipes moistened with 99% isopropyl alcohol.
3. Dry the SC/APC connector with compressed, filtered air or use a dry, lint-free wipe.
GX2 EA1000C*/* Multi-Wavelength DWDM 1550 nm Laser Transmitter • User Guide
589569-001-a

Figure 10: Cleaning the SC/APC connector tip

B
20