Handling The Remote Controller - Hitachi CMP307XE User Manual

All manuals and user guides at all-guides.com

Handling the Remote Controller

Loading Batteries
Open the battery cover.
Slide the battery cover towards the arrow mark while pressing it.
Load batteries.
Load two Size AA batteries included observing the correct
polarities.
When replacing the batteries, always use the R6P AA (or
SUM-3) type.
Close the battery cover.
Slide back the battery cover towards the arrow mark.
Handling the Remote Controller
Use the remote controller within about 5 m from front
of the unit's remote-control sensor and within 30
degrees on both sides.
Do not use batteries of any kind not recommended for this product.Do not use
new and old batteries together. The batteries could explode or leak, resulting in
fires, physical injury, or stains.
When loading batteries, observe their correct polarities as marked on the
product. If loaded in the wrong direction, the batteries could explode or leak,
resulting in fires, physical injury, or stains.
Do not drop or impact the remote controller.
Do not splash the remote controller with water or put it on a wet object to avoid
possible failures.
Before leaving the remote controller out of use for an extended period of time,
TIPS
remove the batteries from it.
If the remote controller begins to lack responsiveness, replace the batteries.
Strong light such as direct sunlight impinging on the photoreceptor of the remote
control can cause operational failure. Position this unit to avoid direct contact
with such light.
With in 30 With in 30
degrees degrees
About 5m
SELECT
13