Table of Contents
Advertisement
All manuals and user guides at all-guides.com
Signal Check
The status of signal reception is checked automatically and the result is displayed on the screen.
Status
•The input terminal and the horizontal and
Signals are received
vertical frequencies are displayed in a
normally.
guidance image.
•The guidance message "POWER SAVE" is
A sync signal could
displayed for about 5 seconds.
not be detected.
•In the event of continued absence of a
*Also includes the
sync signal, the power indicating lamp
status of the VESA-
flickers and the monitor enters power save
DPMS sync signal.
mode.
The input signal
does not meet
•The guidance message "OUT OF
display
FREQUENCY" is displayed for about 5
specifications or
seconds.
erratic.
25
27
Switching the Display Method
The display method can be switched by changing the settings of the display area (when the RGB input
jack is selected) or display size (when the Video input jack is selected).
Switching when the RGB input jack is selected
Input signal(
27
)(Resolution)
640 x 400
640 x 480
800 x 600
832 x 624
1024 x 768
1280 x 1024
19
1) The expanded processing method (
2) The display status and display area is changed each time the SELECT button is pressed, or each time the
the remote control are pressed. (Refer to
signal conditions.
To maximize display performance, it is recommended that the 1024 x 768
HINTS
(vertical frequency 60Hz) input signal specifications be used.
Display
Display area setting (DISPLAY AREA)
NORMAL (normal number of pixels)
640 x 400
640 x 480
800 x 600
832 x 624
1024 x 768
1024 x 768
2)
(Squeezed display, partial display)
INTERPOLATION) becomes effective.
Display Area) Display may not be correct in some cases, depending on the
18
Exemple
RGB1 [D-SUB]
H : 46.5kHz, V : 60Hz
POWER SAVE
OUT OF FREQUENCY
FULL (expanded number of pixels)
1024 x 768
1)
or
keys of
21
Advertisement
Table of Contents
