Table Of Contents - Toro Z Master Professional 5000 Series Setup Instructions

Procedure
14
15
16
17
18
19
20
1
Removing the Machine
from a Crate
Parts needed for this procedure:
2
Rear wheels (wooden crate only)
Removing a Machine from a Metal
Crate
If you are removing the machine from a metal crate,
refer to the Dealer/Distributor Portal for further
information.
Removing the Machine from a
Wooden Crate
1. Remove the screws holding the right angle
retaining plate to the crate.
Description
Air-cleaner cap
Hose clamp
Rollover Protection System (ROPS) Kit
Roll bar, right section
Roll bar, left section
Roll bar, center section
Bolt (3/8 x 1 inch)
Curved washer
Flange nut (3/8 inch)
Bolt (1/2 x 3-1/4 inches)
Flange nut (1/2 inch)
No. 2 lithium or molybdenum grease.
(Purchase separately.)
No parts required
No parts required
Operator's Manual
Engine Owner's Manual
Registration card
Operator training material
Key
Qty.
1
Install the air-cleaner cap (international
machines using gasoline only).
1
Install the ROPS (international machines
1
using gasoline only).
1
1
1
8
Install the ROPS (diesel machines only).
8
8
2
2
1 tube Check the machine for grease.
Remove the shipping straps (for
-
machines with MyRide™ suspension
system only).
Check the machine before delivery to
-
the customer (all machines).
1
1
Deliver the machine to the customer (all
1
machines).
1
2
Gasoline Machine Shown
2
Use
Figure 1
g010179