Protecting The Environment - DeWalt DCF6201 Instruction Manual

Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
For best performance regularly clean magazine by:
1. Remove advancing mechanism from collated magazine
(see removing and Installing the advancing
Mechanism instructions).
2. Remove shoe from advancing mechanism.
3. Remove return spring from magazine.
4. Submerge parts in soapy water for 10 minutes.
5. Remove and thoroughly rinse parts.
6. Allow parts to air dry.
7. Reassemble and continue use.
Removing and Installing the Advancing
Mechanism (Fig. H)

CAUTION: The advancing mechanism is spring
loaded. Two hands must be used to remove the
advancing mechanism. The spring may eject from the
mechanism.
To remove advancing mechanism:
1. Remove collated magazine attachment from
screwdriver.
2. Slightly depress advancing mechanism
on the shoe with one hand.
5
3. Keeping pressure on the shoe
depress service button
6
4. Slowly release pressure from the shoe
advancing mechanism is out of the collated magazine.
Fig. H
11
4
5
12
4 by pushing
with the other hand
5
.
5 until the
10
9
6
To install the advancing mechanism:
5. With the collated magazine attachment removed from
screwgun, align the tabs
10 in the collated housing.
6. Push in slightly, then align the spring
pocket in the advancing mechanism.
7. Push advancing mechanism in until you hear the "click"
of the service button.
NoTE: The lever arm 12
(as shown in figure H) before the advancing mechanism
is installed. If in the down position, the advancing
mechanism will be locked in place.
8. Cycle the advancing mechanism several times by hand
to ensure proper function before installing it onto your
screwgun for use.
Accessories

WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
Repairs
The charger and battery pack are not serviceable.

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a D WALT factory service center
e
or a D WALT authorized service center. Always use
e
identical replacement parts.

Protecting the Environment

Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. .
ENglIsh
9 on the shoe with the slots
11 with the
should be in the up position
WALT
e
17