Manual Channel Scan - Sharp TU-R162H Operation Manual

is 0000, if you change the pin code make sure you write it down and keep it safe.
5.3. LANGUAGE
In this menu the user can adjust the preferred language. Language is changed by pressing OK on the
remote control.
Menu: shows the language of the system
Preferred
These settings will be used if available. Otherwise the current settings will be used.
Ø Audio: by pressing "3/4" on the remote control change the audio language.
Ø Subtitle: alter the subtitle language with"3/4" on the remote control. The chosen language will
be seen in subtitles.
Ø Guide: by pressing "3/4"on the remote control change the guide language.
Current
Ø Audio: if audio language is supported change the audio language by pressing "3/4"on the
remote control.
Ø Subtitle: if subtitle is backed up alter the subtitle language using "3/4"on the remote control. The
chosen language will be seen in subtitles.
5.4. INSTALLATION
5.4.1. AUTOMATIC CHANNEL SCAN
Automatic channel
activated by selecting OK when
the line is highlighted. A pop-up
menu appears on the screen,
select "YES" the automatic scan
begins. All the multiplexes are
searched and a channel table is
created automatically.
channels found are stored in a
sorted form with respect to their channel numbers. Selecting "NO" will cancel the operation.

5.4.2. MANUAL CHANNEL SCAN

In manual search the number of the multiplex is entered manually and only that multiplex is searched
for the channels. In manual and auto search, any existing channel in the database is not re-stored to
avoid redundant duplicates of that channel. To start the scan enter the channel number manually and
press OK.
scan is
All
28