First Time Installation - Sharp TU-R162H Operation Manual

5.4.3. FIRST TIME INSTALLATION

Use this option to load default settings, which had been set at the factory. To install factory settings,
highlight 'First Time Installation' menu and press OK on the remote control, then you will be asked to
confirm deleting all channels and settings. Selecting YES and pressing OK will delete the channel
table. Selecting "NO" and pressing OK will cancel the operation.
6. MESSAGES
When the box receives no signal (e.g. the antenna cable is disconnected), "NO SIGNAL" message is
seen on the screen.
When there are no channels stored in the box; the Channel List menu is not accessible. Channel
navigation is not allowed. Therefore, trying to enter these menus or navigate the channels will display
an error message on the screen.
A conflict is caused, if more than two programmes are set for recording in the same time interval. To
solve this conflict, you have to select an alternative for one of those programmes. If there are no
alternatives, the warning message on the right will appear.
If there is still a conflict and you leave this menu by pressing OK on the remote control, you will see
this warning message: "There are still conflicts!".
29