Change Base Pin Code; Dial Mode; Recall Mode; Restore Default Settings - Motorola C4 Manual

6.3

Change base PIN code

Some functions are protected by a 4 digit PIN code which
must be entered if you want to change the settings. The
default PIN is 0000. You can change this to your own
preferred number.
When you enter a PIN, the digits are shown as ****.
m d
1. Press , scroll to
d
PIN CODE
2. Scroll to and press
3. Enter the 4 digit PIN code (default = 0000) and press
4. Re-enter the new PIN again and press
IMPORTANT
If you change the PIN code, please keep a record of the new
number.
6.4

Dial mode

Your C4 is set to tone dialling. You should only need to
change this if connected to an older type of switchboard/PBX
which requires Pulse dialling.
m d
1. Press , scroll to
d
DIAL MODE
2. Scroll to and press
u d
3. Press or to select
m
press to confirm.
22
m
SETUP
and press .
m
.
m
to confirm.
m
SETUP
and press .
m
.
TONE DIAL PULSE DIAL
or and
6.5

Recall mode

Depending on your country and network operator, your C4
has the recall time set as 600 ms (RECALL 2). It is unlikely
that you need to change this setting unless advised to do so.
m
1. Press , scroll
d
RECALL
2. Scroll to
u d
3. Press or
RECALL 2
(long flash time) and press
m
.
6.6

Restore default settings

You can restore your C4 to its default (original) settings.
All the handsets that are registered to the base will be
retained.
WARNING
Resetting your phone to its default settings will delete all
entries in the Phonebook and Calls list. All handset and base
settings will also be reset.
m
1. Press , scroll
d
DEFAULT
2. Scroll to
3. Enter the 4 digit PIN code (default = 0000) and press
The display shows
m
4. Press to confirm or
Your C4 will restart automatically.
d m
SETUP
to and press
m
and press .
RECALL 1
to select (short flash time) or
m
to confirm.
d m
SETUP
to and press
m
and press .
CONFIRM ?
.
n
to return to the previous menu.
.
.
m
.
Base settings