Table of Contents
Advertisement
Line1 and Line2 are available. Line0 is dedicated input.
- Select the polarity of each signal
Set the following value to "LineInverterAll" register. The setting value is Integer type.
Each bit corresponds to each Line. All Lines are settable.Inverter is also inserted to UserOutputValue.
(GPIO_Input)
(GPIO_Input/Output)
(GPIO_Output)
● Note
About the details of Timer0Active signal, refer to "TimerControl" of "Functions".
Copyright © 2016 TOSHIBA TELI CORPORATION, All rights reserved.
UserOutputValueAll
0 (*)
1
LineInverterAll
0 (*)
1
Line0
Line2
Line1
LineModeAll
LineInverterAll
GPIO internal circuit diagram
Function
Low level output
High level output
* initial factory setting
Function
non inverted
inverted
* initial factory setting
TriggerSource
Internal Trigger
Timer0Active
UserOutput
ExposureActive
FrameTransfer
FrameActive
FrameTriggerWait
UserOutput
Internal Trigger
LineSource
59 / 92
TimerControl
UserOutputValueAll[2]
UserOutputValueAll[1]
D4253386C
http://www.toshiba-teli.co.jp/en/
Advertisement
Table of Contents
