Table of Contents
Advertisement
Main menu:
"Key detector"
Sub-menu 1
Search
Battery check
*1 For Line 1
*2 For Line 2
*3 If you program these settings using one of the units, you do not need to program the same item using
another unit.
*4 After the Bluetooth device is paired, the device name is displayed.
*5 For CELL 1
*6 For CELL 2
*7 For CELL 3
*8 For CELL 4
*9 This feature allows the unit to automatically adjust the date and time each time caller information
including date and time is received.
To turn this feature on, select "Caller ID auto". To turn this feature off, select "Manual". (Call
Display subscribers only)
To use this feature, set the date and time first (page 16).
*10 The preset melodies in this product are used with permission of © 2007 Copyrights Vision Inc.
*11 If you subscribe to a distinctive ring service, select a tone (tone 1 to 5). If you select a melody, you
cannot distinguish lines by their ringers.
*12 This tone lets you know when you receive an outside call while you are on another line or an
intercom call. If you select "On", the tone sounds 2 times.
*13 This setting is available when you have the key detector (KX-TGA20). Read the installation guide for
more information on the key detector.
*14 For models with supplied key detectors, the display shows "1:Detector1".
*15 If you register 2 or more key detectors.
*16 If you have 2 or more key detectors.
*17 This menu is not displayed when scrolling through the display menus. It is only available in direct
command code.
*18 You can set music play during the hold. The preset melody in this product is used with permission of
© 2006 Copyrights Vision Inc.
*19 If you subscribe to a Call Display service and want to view the caller's information after lifting up the
handset to answer a call, turn off this feature.
*20 The flash time depends on your telephone exchange or host PBX. Contact your PBX supplier if
necessary.
*21 Generally, the line mode setting should not be changed. If the LINE 1 indicator or LINE 2 indicator
does not light when another phone connected to the same line is in use, you need to change the line
mode to "A".
Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each handset.
Important:
R Make sure the unit's date and time setting is
correct (page 16).
TG9541C(en)_0723_ver012.pdf
43
*13
Sub-menu 2
Settings
–
–
1
2
Code
–
#655
–
Handset
MMENUN#720
MbN: Select the desired alarm option. a
MSELECTN
"Off"
Turns alarm off. Go to step 7.
"Once"
An alarm sounds once at the
set time.
2013/07/23
Programming
Unit
–
43
12:24:54
Advertisement
Table of Contents
