Download Print this page
Frigidaire PLEW30S3DCB Installation Instructions Manual
Frigidaire PLEW30S3DCB Installation Instructions Manual

Frigidaire PLEW30S3DCB Installation Instructions Manual

27" & 30" warmer drawer
Hide thumbs Also See for PLEW30S3DCB:

Advertisement

Available languages

Available languages

27" & 30" WARMER DRAWER INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
GENERAL INFORMATION
The Warmer Drawer can be used: As a stand alone appliance or as a combination Warmer Drawer with a built-in oven
mounted above
IMPORTANT: The warmer drawer must be installed on a surface leveled from left to right, rear to front and the surface
must be capable of supporting 100 pounds (45 Kg).
NOTE: A 60" (152 cm) long cable is supplied with the
Warmer Drawer.
Stand Alone Installation
C
B
F
D
E
Minimum distance to floor
41/2" (11,4 cm)
A. HEIGHT
27" Models
10" (25,4 cm)
30" Models
10" (25,4 cm)
D. CUTOUT
HEIGHT
27" Models- Min. 8 3/ 8" (21,3 cm) 25 1/ 2 " (64,8 cm)
Max. 8 5/ 8" (21,9 cm)* 25 3/ 4 " (65,4 cm)
30" Models- Min. 8 3/ 8" (21,3 cm)
Max. 8 5/ 8" (21,9 cm)*
* Note: It is also possible to install this warmer drawer in a
height opening of 9¼" (23.5 cm). Please refer to page 3
for complete instructions.
Printed in United States
Warmer Drawer Dimensions
60" (152 cm)
Cord
Warmer Drawer
A
Warmer Drawer
Cutout
FLOOR
B. WIDTH
C. DEPTH
27" (68,6 cm)
23 3/8" (59.4 cm)
23 3/8" (59.4 cm)
30" (76,2 cm)
E. CUTOUT
F. CUTOUT
WIDTH
DEPTH
23 5/8" (60 cm)
24" (61 cm)
28 1/ 2 " (72,4 cm)
23 5/8" (60 cm)
28 3/4" (73 cm)
24" (61 cm)
IMPORTANT: The Warmer Drawer runs off a single
phase three-wire 120 volt, 60 hertz, AC only electrical
supply with ground.
Combination Warmer Drawer/
30" (76 cm) Built-in Oven Installation
Caution: Two 3" (7,6 cm) wide X 3/
4" (1,9 cm) thick planks have to be
installed and they should be able to
support 200 pounds. (90,7 Kg)
29½"
(74.9 cm)
A
B
H* =10-1/8" (25.7 cm) Min. is a Critical dimension
and must be applied.
A. HEIGHT
27" Models
10" (25,4 cm)
30" Models
10" (25,4 cm)
D. CUTOUT
HEIGHT
27" - Min. 8 3/ 8" (21,3 cm)
Max. 8 5/ 8" (21,9 cm)
30" -Min. 8 3/ 8" (21,3 cm)
Max. 8 5/ 8" (21,9 cm)
1
E
F
G
D
C
B. WIDTH
C. DEPTH
27" (68,6 cm)
23 3/8" (59.4 cm)
23 3/8" (59.4 cm)
30" (76,2 cm)
E. CUTOUT
F. CUTOUT G. HEIGHT
WIDTH
DEPTH
25½ " (64,8 cm) 23 5/8" (60 cm) 1½" (3.8 cm)
Depends on critical
25¾ " (65,4 cm)
24" (61 cm)
dimension H
28½ " (72,4 cm) 23 5/8" (60 cm) 1½" (3.8 cm)
Depends on critical
28¾" (73 cm)
24" (61 cm)
dimension H
P/N 318201806 (0503) Rev. A
English – pages 1-4
Español – páginas 5-8
Français – pages 9-12
H*

Advertisement

loading

Summary of Contents for Frigidaire PLEW30S3DCB

  • Page 1 GENERAL INFORMATION The Warmer Drawer can be used: As a stand alone appliance or as a combination Warmer Drawer with a built-in oven mounted above IMPORTANT: The warmer drawer must be installed on a surface leveled from left to right, rear to front and the surface must be capable of supporting 100 pounds (45 Kg).
  • Page 2: Important Safety Instructions

    27" & 30" WARMER DRAWER INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Read all the instructions contained in these installation instructions before installing appliance. 2. Remove all packing material from the appliance before connecting the electrical supply. 3. Observe all governing codes and ordinances.
  • Page 3 27" & 30" WARMER DRAWER INSTALLATION INSTRUCTIONS B. Installation for a coutout height of 9¼ (23.5 cm) 1. Locate the 2 anti-tip brackets and the 2 front supports supplied as shown on figure 3. Fix them using the 4 black head screws (10-16 X 1¼") supplied 2.
  • Page 4 27" & 30" WARMER DRAWER INSTALLATION INSTRUCTIONS NOTES...
  • Page 5 INSTRUCCIONES DE INSTALACIÓN PARA EL CAJÓN CALENTADOR DE 27" & 30" LA INSTALACIÓN Y EL SERVICIO DEBEN SER EJECUTADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA EL USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA FUTURAS REFERENCIAS. PARA SU SEGURIDAD: No almacene o use gasolina u otros vapores y líquidos combustibles cerca a éste o a cualquier otro electrodoméstico.
  • Page 6: Instrucciones Importantes De Seguridad

    INSTRUCCIONES DE INSTALACIÓN PARA EL CAJÓN CALENTADOR DE 27" & 30" Notas importantes para el instalador 1. Lea todas las instrucciones de instalación antes de instalar el electrodoméstico. 2. Retire todos los materiales de empaque del electrodoméstico antes de conectar la fuente de energía. 3.
  • Page 7 INSTRUCCIONES DE INSTALACIÓN PARA EL CAJÓN CALENTADOR DE 27" & 30" B. Instalación del cajón calentador con una abertura de 9¼ (23.5 cm) 1. Localice los 2 brackets anti-volteo y los 2 apoyos anteriores suministrados como mostrado en la figura 3. Instále los usando los 4 tornillos negros (10-16 X 1¼") suministrados.
  • Page 8 INSTRUCCIONES DE INSTALACIÓN PARA EL CAJÓN CALENTADOR DE 27" & 30" NOTAS...
  • Page 9 * Note : c'est aussi possible d'installer ce tiroir réchaud dans une overture de hauteur de 9¼" (23,5 cm). S'il vous plaît référez-vous à la page 11 pour des instructions complètes. Imprimé aux États-Unis Warmer Drawer Dimensions IMPORTANT: Le tiroir-réchaud fonctionne seulement avec un circuit électrique mis à la terre à 3 fils de 120 volts, monophasé, 60 Hz CA.
  • Page 10: Instructions De Sécurité Importantes

    INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD DE 27" & 30" Notes importantes à l’installateur 1. Lisez toutes les instructions d’installation avant de procéder à l’installation de cet appareil. 2. Retirez tout le matériel d’emballage de l’appareil avant de brancher l’alimentation électrique. 3.
  • Page 11 INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD DE 27" & 30" B. Installation pour une hauteur de découpage de 9¼ (23.5 cm) 1. Localisez les 2 supports anti-bascules et les 2 supports frontaux fournis comme indiqués à la figure 3. Fixez-les à l'aide des 4 vis à noires fournies (10-16 X le 1¼ ») 2.
  • Page 12 INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD DE 27" & 30" NOTES...