Making Connections; Enabling The Computer's External Display; Connecting Your Pc Or Macintosh Computer - Canon LV-7250 User Manual

Making Connections

NOTE: When using with a notebook PC, be sure to connect the projector and notebook PC while the projector is in standby mode
and before turning on the power to the notebook PC.
In most cases the output signal from the notebook PC is not turned on unless connected to the projector before being powered
up.
* If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power
management software.

Enabling the computer's external display

Displaying an image on the notebook PC's screen does not necessarily mean it outputs a signal to the projector.
When using a PC compatible laptop, a combination of function keys will enable/disable the external display.
Usually, the combination of the 'Fn" key along with one of the 12 function keys gets the external display to come on
or off. For more details, refer to your computer's owner's manual.

Connecting Your PC or Macintosh Computer

NOTE:
• LV-7250: The ANALOG IN- 1 connector supports Plug & Play (DDC2).
• LV-X6: The ANALOG IN connector supports Plug & Play (DDC2).
Audio cable
(not supplied)
IBM PC or Compatibles (Desktop type)
or Macintosh (Desktop type)
NOTE: Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor turns down the sound.
NOTE: An image may not be displayed correctly when a Video or S-Video source is played back via a commercially available scan
converter.
This is because the projector will process a video signal as a computer signal at the default setting. In that case, do the following.
* When an image is displayed with the lower and upper black portion of the screen or a dark image is not displayed correctly:
Project an image to fill the screen and then press the AUTO PC button on the remote control or the projector cabinet.
LV-7250
AUDIO IN
AUDIO IN
L
S-VIDEO
IN
SERVICE PORT AUDIO OUT
R
VIDEO
IN
AUDIO IN
PHONE
NOTE: For older Macintosh, use a
commercially available pin adapter
(not supplied) to connect to your
Mac's video port.
2. Installation and Connections
ANALOG IN-1
ANALOG IN-1
ANALOG IN-2
ANALOG IN-2
VGA cable (supplied)
To mini D-Sub 15-pin connector on the projector. It
is recommended that you use a commercially
available distribution amplifier if connecting a
signal cable longer than the supplied one.
PHONE
IBM VGA or Compatibles (Notebook
type) or Macintosh (Notebook type)
14
LV-X6
ANALOG IN
ANALOG IN