Fujitsu 735Dx User Manual page 49

Technologies,and the Windows 95 Control
panel. If no settings have been made in the
PowerPanel or Windows 95 Control panel then
the BIOS settings will be used. The PowerPanel
and Windows 95 Control panel have been
pre-set at the factory and will be active unless
you disable them. Complete descriptions of the
BIOS setup utility parameters are found in
Section Three of this guide. Power management
parameters are covered under the Power
Savings menu. (See pages 81-87.)
Some particular power parameters are only
available for setup from one of these places,
others can be changed in any one of them.
Using the Suspend/Resume Button
When your notebook is active,the Suspend/
Resume button, (Figure 1-7 on page 7), can be
used to manually put your notebook into
Suspend mode, or into the Save-to-Disk mode.
Push the Suspend/Resume button, when your
notebook is active but no Access indicators are
on,and hold it in until it is acknowledged by
activation of the selected mode. Which mode is
U s i n g Y o u r L i f e B o o k 7 0 0 S e r i e s
Figure 2-14 Suspend/Resume Button
activated is determined by the settings of the
BIOS setup utility Power Savings menu. The
default is Suspend mode. (See page 84 for how
to select Save-to-Disk mode.)
If your notebook is suspended,pushing the
Suspend/Resume button will return your note-
book to active operation at the point where it
went into suspension. The Suspend/Resume
button is located next to the Status Indicator
panel above the keyboard of your notebook.
(Figure 2-14) You can tell whether or not your
system is in Suspend mode by looking at the
L i f e B o o k 7 0 0 S e r i e s f r o m F u j i t s u
Power indicator. (See pages 19-20.) If it is visible
and not flashing, your notebook is fully opera-
tional. If it is visible and flashing , your note-
book is in Suspend mode. If it is not visible,
the power is Off,the power is in the Windows
95 pseudo-off state, or your notebook is in
Save-to-Disk mode. (See pages 44-45.) When
you receive your LifeBook 700 Series it will be
set to the default, which is Suspend mode.
C A U T I O N
Be sure you know which settings are
active for the Suspend/Resume button
before you use it; misuse can result in
data loss. (See the Power Savings Menu
of the BIOS setup utility, pages 81-87,
for more information.)
39