Table of Contents
Advertisement
DOCKING YOUR SYSTEM
®
®
Microsoft
Windows
uses "plug- and-play" technology
to automatically load the files necessary to operate your
Tablet Dock and any attached devices.
P O I N T
The following instructions assume the Tablet Dock is
positioned in portrait mode, with the Lock Handle on
the right of the dock.
1. Plug the system's AC adapter into a wall outlet, then
into the Tablet Dock's DC Input jack.
2. Set the ST4000 system on the Tablet Dock, with the
system oriented in the same direction as the dock.
(See Figure 3 for location). The connector in the back
of the system should be aligned with the interface
connector on the Tablet Dock.
Figure 3. Docking the system
3. Carefully push the system towards the docking port
until you hear a click. The click indicates that the side
latches are in place. Note that the system is not yet
locked into place until the following step is
performed.
4. Firmly pull the lock handle down as far as it will go.
This engages the back latches and side latches, and
locks the system in place.
5. Your Tablet Dock is now ready for use. You may now
attach devices to it.
P O I N T
The front portion of the base should not be used as a
handle.It is designed to support the system when it is
installed in the Tablet Dock.
T a b l e t D o c k U s e r ' s G u i d e
UNDOCKING YOUR SYSTEM
Use these instructions when you want to remove your
system from the Tablet Dock.
P O I N T
The system can be removed from the Tablet Dock
whether the system is operating or not.
1. If you are running a CD or DVD in the Tablet Dock
drive, be sure to stop the drive before undocking the
ST4000.
2. Press the lock release button on the top of the right
slide (above the lock handle). While holding it down,
pull the lock handle upwards to unlatch the back
latches from the system.
3. Pull the system upwards, away from the platform.
The system is now undocked.
5
Advertisement
Table of Contents
