Table of Contents
Advertisement
S t y l i s t i c S T 4 0 0 0 S e r i e s T a b l e t D o c k
C A U T I O N
Do not operate your media drive unless your system is
sitting on a relatively flat surface. Using the drive when
the system is not level may damage the drive or prevent
proper operation.
LOADING MEDIA
(Refer to Figure 8 for the following steps)
To load a disc into your media player drive, follow these
steps:
1. Push and release the eject button on the front of the
drive to open the holder tray. The tray will come out
of the system a short distance.
2. Gently pull the tray out until a media disc can easily
be placed in the tray.
C A U T I O N
There may be a protective sheet in the tray from when it
was shipped; please make sure it is removed before
operating the drive.
3. Place the media into the tray, label side up, with the
hole in the center of the disc. Snap the disc onto the
raised circle in the center of the tray.
4. Gently push the holder tray back in until you hear
a click.
REMOVING MEDIA
(Refer to Figure 8 for the following steps)
1. Push and release the eject button on the front of
the media player drive. This will stop the drive and
the holder tray will come out of the system a short
distance.
2. Gently pull the tray out until the disc can easily be
removed from the tray.
3. Carefully remove the media disc from the holder
tray.
4. Gently push the holder tray back in until you
hear a click.
8
Figure 8. Loading/Ejecting Media
Advertisement
Table of Contents
