Toro Groundsmaster 3320 Installation Instructions Manual page 10

4. Secure the harness to stationary frame components with
cable ties.
Mount Hopper Assembly
1. Remove the tie straps securing the tie rods to the hopper
arms. Install (2) 5/16 – 18 x 1" lg. carriage bolts and
flange nuts in hopper arm holes where tie straps
previously were.
2. Slide the hopper assembly (hopper cover to rear) into
the side frame while aligning the mounting holes in
hopper with the holes in frame (Fig. 17).
2
Figure 17
1. Hopper assembly
3. Secure the hopper to the frame with (2) welded
mounting pins and hair pin cotters (Fig. 17).
4. Secure the hopper tie rods to the frame with hair pin
cotters (Fig. 18).
1
Figure 18
1. Hopper tie rod
5. Adjust the tie rods up or down to make sure the hopper
is level with the machine and it does not contact the
machine during operation.
2
1
2. Mounting pins
10
Install Front Blowout Shields
Note: The following instructions are as viewed from the
front of the machine.
When hopper is used with a 52" Deck
1. Secure the wide shield to the left inside lip of the
hopper opening with a long flat, (3) #10 – 24 X 1" lg.
screws and #10 – 24 flange nuts (Fig. 19).
2
5
2
Figure 19
1. Wide shield
2. Long flat
3. Narrow shield
2. Secure the narrow shield to the right inside lip of the
hopper opening with a long flat, (3) #10 – 24 X 1" lg.
screws and #10 – 24 flange nuts (Fig. 19).
3. Secure the top shield to the upper inside lip of the
hopper opening with a short flat, (2) #10 – 24 X 1" lg.
screws and #10 – 24 flange nuts (Fig. 19). Use the (2)
mounting holes on the right side of the opening only.
When hopper is used with a 60" Deck
1. Secure the wide shield to the right inside lip of the
hopper opening with a long flat, (3) #10 – 24 X 1" lg.
screws and #10 – 24 flange nuts (Fig. 20).
2. Secure the narrow shield to the left inside lip of the
hopper opening with a long flat, (3) #10 – 24 X 1" lg.
screws and #10 – 24 flange nuts (Fig. 20).
3. Cut 1–1/2" of material off the bottom edge of the top
shield. Secure the top shield to the upper inside lip of
hopper opening with a short flat, (2) #10 – 24 X 1". lg.
screws and #10–24 flange nuts (Fig. 20). Use the (2)
mounting holes on the left side of the opening only.
4
3
1
4. Narrow shield
5. Short flat