Toro Groundsmaster 3320 Installation Instructions Manual page 11

6
3
1
Figure 20
1. Wide shield
2. Long flat
3. Narrow shield
Mount Wheel Weight
1. Measure the depth of the wheel rim. This is achieved by
measuring the distance from the hole to the outside edge
of the rim.
2. Add 3–7/8" to the measurement attained. This becomes
dimension "A" in figure 21.
3. Thread a hex nut onto each threaded rod to the "A"
dimension.
4. Insert the threaded rods through two opposite holes in
the rim and secure them in place with 1/2" lockwashers
and hex nuts (Fig. 21).
2
1
Figure 21
1. Wheel weight
5. Place the wheel weight over the ends of the threaded
rods and secure in place with flatwashers, lockwashers
and hex nuts (Fig. 21). Do not overtighten the hex nuts
or damage to the plastic housing of the weight may
occur.
2
5
2
4
4. Narrow shield
5. Short flat
6. Cut off 1–1/2"
2. Threaded rod
11
Note: If there is excess thread protruding from the nuts or
inside of wheel, cut it off with a hacksaw. The threaded rod
must not contact any parts of the machine when the wheel
is rotating.
Important
Refer to the weight chart in the Traction
Unit Operator's Manual for additional weight requirements.