Ext.in Menu; Error Messages - Sony URX-P03D/25 Operating Instructions Manual

EXT.IN Menu

This menu allows you to configure settings for the
microphone connected to the unit's external input
connector.
Selecting the external microphone type
(MIC SELECT)
Select which type of microphone is connected to the
external input connector.
OFF: Select this when not using an external microphone.
PLUG-IN PWR: Select this when using a plug-in power
microphone.
MONO BMP +5V: Select this when using a Sony
lavalier microphone.
Adjusting the input level (INPUT LEVEL)
Set the input level to a value between –12 to +12 dB.
Adjust the value according to the type of microphone that
is connected.
The factory default setting is 0 dB.
Setting the low-cut filter (LCF)
You can set the low-cut filter to reduce noise caused by
wind.
You can set the cutoff frequency to OFF/LOW/MID/
HIGH.
OFF: No filtering
LOW: 100 Hz cutoff frequency
MID: 150 Hz cutoff frequency
HIGH: 200 Hz cutoff frequency
Switching the phase of the microphone
(PHASE)
You can switch the phase of a connected microphone to
output audio in reverse phase.
NORMAL: Phase is not reversed.
INVERT: Reverses the internal phase.
Selecting the output connector for audio
inputs (ASSIGN)
Select the connector from which to output signal inputs.
OUT1: Output the audio from the OUTPUT 1 connector.
If the connected microphone is an LR type, the output will
be mixed.
OUT1/2 (L/R): Output the audio from both the OUTPUT
1 and OUTPUT 2 connectors. If the connected
microphone is an LR type, L will be output from the
OUTPUT 1 connector and R will be output from the
OUTPUT 2 connector.
OUT2: Output the audio from the OUTPUT 2 connector.
If the connected microphone is an LR type, the output will
be mixed.

Error Messages

When a problem occurs, one of the following error
messages may appear on the display.
Message Meaning
EEP ERROR An error has
occurred in the
backup memory
data.
PLL ERROR An error
occurred in the
PLL synthesizer
circuit.
NO TONE Audio signal
output has been
muted, because
a tone signal
different from
the compander
mode
configured on
the unit was
received.
15
Solution
Contact your Sony
service representative.
Restart the unit. If the
message persists,
contact your Sony
service representative.
Configure the
appropriate compander
mode based on the
transmitters you are
using "Setting the
Compander Mode"
(page 10).
When operating in
conjunction with UWP-D
series transmitters
(UTX-B03, UTX-M03,
etc.), set the unit and the
transmitters to the same
compander mode.