Clip management (continued)
Adding shot marks to clips
You can differentiate one clip from all the other clips by adding shot marks.
1
Display the thumbnail display screen.
With cross cursor operation, move the cursor to the target clip.
Press [USER] in which the shot mark function was allocated. (Page )
To release a shot mark, repeat the above steps.
If the video data created by a shooting session consists of a multiple number of clips, it will not be
possible to add or release the shot marks unless all the P2 cards containing the video data are inserted
into the slots.
•
Shot marks cannot be added into the clips on a card whose write protect switch is at the PROTECT
position.
•
Shot marks can be added during recording as well. (Page 63)
•
Shot marks cannot be added or released during playback.
•
Shot marks cannot be added or released during LOOP REC.
Displaying the P card status
The statuses of the P2 card slots, operation statuses of the P2 cards and other card information can be
displayed on the screen, and checked.
1
Display the thumbnail display screen.
Press [MENU/MODE CHK].
Using
,
and
– "PROPERTY SETUP" – "P CARD CAP",
and press
.
Use
and
to select the item to be set,
and press
.
REMAIN:
USED:
5
Press
.
6
Using
and
and press
.
5
, select "PROPERTY"
Remaining memory display
(default value)
Used memory display
, select "CARD STATUS",
[When REMAIN has been selected]
1 )
2 )
5 )
4 )
[When USED has been selected]
1 )
2 )
5 )
4 )
3 )
3 )