Table of Contents
Advertisement
CARE AND CLEANING
After using the RCK3 VCI, a few simple steps will help you leave the electronic control units in
the proper state and also ensure that you get the most use out of your diagnostic tool:
1. Before turning the RCK3 VCI off, exit any PC computer application.
2. Disconnect the RCK3 VCI Connector Cable from the motorcycle.
3. Disconnect the USB cable from the PC and the RCK3 VCI.
4. Inspect the cables and connectors for damage and corrosion. Replace faulty
components immediately.
5. Store the RCK3 VCI, cables, and other parts in a secure, dry location.
If the RCK3 VCI, connectors, or cables become dirty, they may be cleaned by wiping them
with a rag lightly coated with a mild detergent or non-abrasive hand soap. Do not immerse the
RCK3 VCI or any of its parts or accessories in water. Avoid using harsh solvents such as
petroleum based cleaning agents, Acetone, Benzene, Trichloroethylene, etc. Thoroughly dry
the RCK3 VCI and accessories prior to storage.
TAKING THE PRODUCT BACK AND RECYCLING
Applicable to products that are sold into the European Union, the European Union has passed
a directive called Waste Electrical and Electronic Equipment, or WEEE for short, to ensure that
systems are setup throughout the EU for the collection, treating and recycling of electronic
waste.
This ensures that the devices are recycled in a resource-saving way representing no danger to
health or the environment.
The WEEE symbol is shown at the right.
The WEEE symbol on the product or its packaging shows that the product must not be
disposed of as residual garbage. The user is obliged to collect the old devices separately and
return them to the WEEE take-back system for recycling (http://www.weee-forum.org).
Version 1.0.2
2015
BMW RCK3 VCI User Manual
Page 13
© Bosch
Advertisement
Table of Contents
