Changing The Language Setting - Sony Handycam DCR-SR32E Instruction & Operation Manual

3
Set [SUMMERTIME], then touch
[NEXT].
4
Set [Y] (year) with v/V.
5
Select [M] with b/B, then set the
month with v/V.
6
Set [D] (day), hour and minute in
the same way, then touch [NEXT].
7
Make sure that the clock is
correctly set, then touch
The clock starts.
You can set any year up to the year
2037.
To turn off the power
Turn the POWER switch to OFF (CHG).
To reset the date and time
(HOME) t
Touch
t [CLOCK/
SET], and set the date and time.
b Notes
• If you do not use your camcorder for about 3
months, the built-in rechargeable battery gets
discharged and the date and time settings may
be cleared from the memory. In that case,
charge the built-in rechargeable battery and then
set the date and time again (p. 116).
18
(SETTINGS)
LANG] t [CLOCK
• It takes a few seconds for your camcorder to be
ready to shoot after the power is turned on. You
cannot operate your camcorder during this time.
• The lens cover opens automatically when the
power is turned on (DCR-SR190E/SR200E/
SR290E/SR300E). It closes when the playback
screen is selected, or the power is turned off.
• In the setting at the time of purchase, the power
turns off automatically if you leave your
camcorder without any operation attempted for
approximately 5 minutes, to save battery power
([A.SHUT OFF], p. 64).
z Tips
• The date and time does not appear during
recording, but they are automatically recorded
on the hard disk, and can be displayed during
playback ([DATA CODE], p. 60).
• Refer to page 109 for information concerning
"World time difference."
• If the buttons on the touch panel do not work
correctly, adjust the touch panel
(CALIBRATION) (p. 115).

Changing the language setting

You can change the on-screen displays to
.
show messages in a specified language.
Touch
t [CLOCK/
[ LANGUAGE SET], then select the
desired language.
(HOME) t
(SETTINGS)
LANG] t