Table of Contents
Advertisement
NOTE
1.
Before your operation, please read "PREPARATION OF
SERVICING".
2.
Use the Lead Free solder.
3.
Manual soldering conditions
• Soldering temperature: 320 ± 20˚C
• Soldering time: Within 3 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
4.
When Soldering/Removing of solder, use the drawing
equipment over the Pick Up Unit to keep the Flux smoke
away from it.
5.
When installing the DVD Deck, remove all the soldering on
the short circuit position after the connection of Pick Up
PCB and DVD PCB connector.
1-5: DVD DECK (Refer to Fig. 1-5)
Remove the 2 screws 1.
1.
Remove the 2 screws 2.
2.
3.
Remove the DVD Deck in the direction of arrow.
2
1
1-6: LCD PCB (Refer to Fig. 1-6)
Remove the screw 1.
1.
2.
Remove the MPEG Shield.
3.
Disconnect the following connectors:
(CP102, CP103, CP104, CP801 and CP3805).
Remove the 4 screws 2.
4.
5.
Remove the PCB Angle in the direction of arrow (A).
Remove the 4 screws 3.
6.
7.
Remove the LCD PCB in the direction of arrow (B).
DISASSEMBLY INSTRUCTIONS
2
1
DVD Deck
Fig. 1-5
2
MPEG Shield
1
3
1-7: LCD PCB (Refer to Fig. 1-7)
1.
Disconnect the following connectors:
(CP101, CP705, CP1001, CP2201 and CP3803).
Remove the 6 screws 1.
2.
3.
Remove the LCD PCB in the direction of arrow.
CP1001
CP705
CP101
1-8: SIDE JACK PCB (Refer to Fig. 1-8)
Remove the 3 screws 1.
1.
2.
Remove the Jack Plate, Jack Shield and Side Jack PCB in
the direction of arrow.
B1-2
2
PCB Angle
2
2
CP801
(B)
LCD PCB
3
3
3
CP104
(A)
CP3805
CP102
CP103
CP2201
1
1
1
1
1
1
CP3803
LCD PCB
Fig. 1-6
Fig. 1-7
Advertisement
Table of Contents
