Advertisement
Figure 15
1. Shoulder bolt
2. Adjuster-arm rod
5.
Tighten the carriage bolts and locknuts securing
the HOC bracket assemblies to the side plates
(Figure
16).
Figure 16
1. Adjusting bolt
2. Locknut
3. Carriage bolt and flange
locknut (3/8 with 5/8 inch
hex)
g346925
3. Adjuster collar
4. Idler assembly
g346926
4. Flange nut
5. Cap screw
6.
Tighten the locknut on the HOC adjuster bolt,
then back off the locknut 1/2 turn
7.
Center the front roller between the HOC bracket
assemblies and lock it in place with the cap
screws and flange nuts
8
Installing the Groomer
Drive Cap
For Cutting Units without a Rear
Roller Brush Kit Only
Parts needed for this procedure:
Cap (for universal groomer assemblies with no rear
3
roller brush kit installed only)
Procedure
1.
Clean the mounting area on the gearbox
17).
1. Groomer drive cap
2.
Apply a light coat of Loctite 609 retaining
compound (green) to the mounting area.
3.
Install the groomer drive cap onto the mounting
area
(Figure
17).
10
(Figure
(Figure
16).
Figure 17
2. Mounting area
16).
(Figure
g355416
Advertisement
