Advertisement
8.
Use a syringe (Part No. 137-0872) to fill the
drive box with 80-90W oil (approximately 90 cc).
Figure 31
1. Syringe with 80-90W oil
9.
Install the fill plug and tighten the air-vent plug.
10.
Torque all plugs to 3.62 to 4.75 N∙m (32 to 42
in-lb).
Figure 32
Right side groomer box shown
1. Air-vent plug
2. Fill plug
g346931
2. Fill port
g346930
3. Drain plug
Removing the Groomer
Drive Box
Note:
Retain all removed parts for later installation
unless otherwise stated.
Important:
If you have any issues removing the
groomer drive box, refer to your traction unit
Service Manual or contact your authorized Toro
distributor.
1.
Remove the cap from the groomer.
2.
Remove the clamp bolts connecting the groomer
to the drive box
3.
Remove the shoulder bolt and hardened washer
connecting the groomer drive box to the adjuster
arm
(Figure
33).
1. Shoulder bolt
2. Hardened washer
4.
Restrain the reel for removal; refer to
the Reel for Removing Threaded Inserts (page
21).
5.
Install the reinforcement screw (Part No.
1-803022—sold separately) to the internal
threads of the groomer drive hex head and
torque to 13.5 N⋅m (120 in-lb) as shown in
Figure
33.
6.
Remove the groomer drive box from the cutting
reel by turning the groomer drive hex-head
(Figure
33).
Important:
If the groomer drive box is
installed on the right side of a cutting
unit, turn the groomer drive hex-head
counter-clockwise (right-hand thread) to
remove the drive-box shaft from cutting unit.
Important:
If the groomer drive box is
installed on the left side of a cutting unit,
20
(Figure
18).
Figure 33
3. Groomer drive hex-head
4. Reinforcement screw
Restraining
g346932
Advertisement
