Table of Contents
Advertisement
Fig. 12
NOTE
When the cutter has difficulty ejecting or collect-
ing dust.
The cutter outlet may be clogged with dust. Open
the front cover and remove any dust.
Control Panel
(1) LED light
Fig. 13
Pressing
(LED light ON/OFF button) toggles
the LED light on and off.
The light illuminates with very low current, and it
does not adversely affect the performance of the
tool during use or its battery capacity.
CAUTION:
• The built-in LED light is designed to illuminate
the small work area temporarily.
• Do not use it as a substitute for a regular
flashlight, since it does not have enough
brightness.
• Power automatically turns off immediately after
the battery pack is installed or when the LED
light is on and the driver has not been used for
5 minutes or more or when the LED light is
turned off and the driver has not been used for
1 minute or more. Please depress the switch to
operate the drill again.
This tool has the built-in LED light.
This tool is classified into "Class 1 LED Product"
to IEC (EN) 60825-1:2001.
Class 1 LED Product
Caution: DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance of
procedures other than those specified herein
may result in hazardous radiation exposure.
(2) Overheat warning lamp
The overheating protection feature halts tool
operation to protect the battery pack in the
event of overheating. The overheat warning
lamp on the control panel flashes when this
feature is active.
• If the overheating protection feature acti-
vates, allow the tool to cool thoroughly (at
least 30 minutes). The tool is ready for use
when the overheat warning lamp goes out.
• Avoid using the tool in a way that causes
the overheating protection feature to acti-
vate repeatedly.
(3) Battery low warning lamp
Excessive (complete) discharging of lithium
- 11 -
Advertisement
Table of Contents
