Philips 1000 Series User Manual page 7

Insert the earpieces
1
Check left or right orientation of the
earpiece.
2
Insert the earpieces into the ears
and twist slightly until a secure t is
achieved.
Pair the headphones
with your Bluetooth
device for the rst time
1
Make sure that the earphones is
fully charged and powered o .
2
Open the top cover from charging
box. The earphones will power on
automatically, entering pairing
model and Right & Left earphones
connected.
Light on both earphoness is
blinking (white and blue)
The earphones is now in
pairing mode and is ready to
pair with a Bluetooth device
(e.g. a mobile phone).
3
Turn on the Bluetooth function of
your Bluetooth device.
4
Pair the headphones with your
Bluetooth device. Refer to the user
manual of your Bluetooth device.
6 EN
Note
 After powering on, if the earphones cannot
nd any previously connected Bluetooth
device, it will automatically switch to pairing
mode.
The following example shows you
how to pair the earpieces with
your Bluetooth device.
1
Turn on the Bluetooth function of
your Bluetooth device, select
Philips TAT1207.
2
Enter the earpieces' password
"0000" (4 zeros) if prompted. For
those devices featuring Bluetooth
3.0 or higher, there is no need to
enter a password.
Single earpiece (Mono mode)
Take either right or left earpiece out
from charging box for Mono use. The
earpiece will power on automatically.
You will hear a voice from the earpieces
saying "Power on".
Note
 Take the second earpiece from the charging
box and they will pair with each other
automatically.
Philips TAT1207