Print Site File - GE DigitalFlow DF868 Programming Manual

March 2008

Print Site File

4-8
PROG
Use the submenu to print the data in a site file that was set up
and saved as described in Chapter 1, Programming Site Data. To print
a site file, refer to Figure A-7 in Appendix A, Menu Maps, and
complete the following steps:
IMPORTANT:
Make sure that a printer has been properly set up
before proceeding with this section.
1. To access the Print Menu, press the
Note: The Print Menu is not protected by the security feature and a
password is never required to access this menu.
[F3] PROG
2. Press = .
3. Use the [←], [→] and
to print.
Note: All site files currently in memory appear on the option bar.
The currently active site file (or working file) is always listed
as the first choice
The Model DF868 returns to the standard data display screen and
generates a site file printout similar to the one shown in Figure 4-5
below. The printout continues until the entire file has been printed or
STOP
until a command is issued (see the instructions for the
submenu on page 4-9).
PROGRAM PARAMETERS of SITE NAME
Model GX868G3G
With 1K FIFO and 1113 receiver board.
At 9:54:39 AM on 11 FEB 99
ACTIVE PARAMETERS:
Site status
Skan/measure mode
SYSTEM PARAMETERS:
site LABEL
System Units
Totalizer Option
Equation
Supercompress?
Volumetric Units
Volumetric Time
VOL Decimal Digits
Totalizer Units
TOT Decimal Digits
PIPE PARAMETERS:
Transducer number
Pipe OD
Pipe Wall
Path Length
Axial Dimension L
.
.
.
Figure 4-5: A Typical Site File Printout
[PRNT]
key.
[F1]-[F4]
keys to select the desired Site File
(Work) on the option bar
.
Burst
Skan Only
site MESSAGE
ENGLISH
Automatic
Standard Equation
No
Thousands ACF
/min
0
Actual cubic ft
0
81
12.000 inches
0.200 inches
16.97 inches
12.00 inches
.
.
.
STOP
Printing Data