Reynolds Correction - GE DigitalFlow DF868 Programming Manual

NO Additional Selections
WATER Enter the Water Temperature and
press [ENT].
MIXED Enter the Fluid Soundspeed and
press [ENT]. Then enter Percentage
of Water and press [ENT].
OTHER Enter the Fluid Soundspeed and
press [ENT].

Reynolds Correction

Programming Site Data
Table 1-10: Fluid Types for ENERGY ON
Tracking Windows =
W260
MIXED
OTHER
[F1]
11. Press to turn Reynolds Correction off, or
Note: Reynolds Correction is a number based on the Kinematic
Viscosity and flow rate of the fluid. It should be enabled for
most applications. Also, if you have enabled a temperature
compensation table (see page 1-55), a message indicates that
the table is active.
12.When you enable the Reynolds Correction Factor, you must also
enter the Kinematic Viscosity of your fluid, as listed in Sound
Speeds and Pipe Size Data. Use the numeric keys to enter a value,
[ENT]
and press .
YES Additional Selections
No additional selections required.
Enter the Percentage of Water and
press [ENT].
Enter the Minimum Soundspeed and
press [ENT]. Then enter Maximum
Soundspeed and press [ENT].
March 2008
[F2]
to turn it on.
1-19