Bosch rexroth HyDrotrAC GFt Operating Instructions Manual page 33

4. Transport the planetary gearbox to the application machine.
5. Make sure that the surface is stable.
6. Place the planetary gearbox with the cover plate down on two suitable squared
timbers. Secure the planetary gearbox against tipping over.
7. Attach the planetary gearbox carefully using appropriate means of attachment
e.g. eye bolts, swivel hooks, shackles or suitable equipment on an appropriate
lifting equipment such as a crane hook. Refer to chapter 6.1 "Transporting the
HYDROTRAC GFT".
8. Tighten the means of attachment without lifting the planetary gearbox.
9. Make sure that the part of the machine or chassis frame to which the planetary
gearbox is to be mounted is free of dirt and foreign objects.
10. Lift the planetary gearbox into the machine or chassis frame.
11. Attach the planetary gearbox to the machine or chassis frame. For the required
strength class of the mounting screws as well as the necessary tightening
torques is the machine or vehicle manufacturer liable. The required mounting
screws are not included within the scope of supply.
12. Remove all means of attachment, transport and lifting equipment.
13. Remove the dust cap 18 and the thrust cup.
procedure Installing the axial-piston motor to the planetary gearbox:
Failure or damage to the planetary gearbox!
An O-ring forgotten during assembly or installed improperly on the axial-piston
motor may cause leakage or failure of the planetary gearbox!
f Observe correct O-ring size depending on the O-ring groove of the axial-piston
motor.
f Ensure that the O-ring is installed correctly in the corresponding O-ring groove
of the axial-piston motor.
If Rexroth delivers the hydrostatic drive without axial-piston motor, the
operating instructions of the axial-piston motor are not included within the
scope of supply. Observe the operating instructions of the axial-piston motor
(provided by the manufacturer of the axial-piston motor). This is where you will
find all the required information on assembly and commissioning of the axial-
piston motor.
Assembly | HyDrotrAC GFt >130 knm
CAUtion
CorreCtion Copy 1 |17.10.2019 | onLy For internAL USe
RE 79094, Issue 10.2019, Bosch Rexroth AG
33/64