Additional Information - Beko 19WLP530HID Operating Instructions Manual

7

ADDITIONAL INFORMATION

7.1 Troubleshooting
Failure
The television does not function
Poor picture quality
Shadow and reflection in the
picture.
No picture
No colour.
No or defective teletext
No sound
Remote control does not work
Picture is not visible after turning
on the TV
If your television does not work properly even though you tried the above mentioned
solutions, try turning it on and off again. If you cannot start your television even though you
have applied all noted methods, Never attempt to repair a faulty TV yourself call the
Helpdesk: 0845 600 4911
Helpdesk: 0845 600 4911
Possible cause
Is the mains cable connected to the
mains supply?
Is the Power On/Off button on?
Is the aerial cable connected?
If you are using a satellite, is it well
adjusted?
Aerial may be affected by two
connected external devices.
It may need fine tuning.
Picture settings are not correct.
Channel setting
Antenna
Is there any damage to the aerial
cable?
Are you sure you pressed the
correct button on your remote
control?
Colour intensity level is at the lowest
setting.
Broadcast system setting (if setting
choice is available)
Problem in channel broadcasting.
Television channel (no teletext) or
aerial system.
Very weak signal
Temporary sound mute may be on
Is the sound turned down?
Are the batteries correctly placed?
Are batteries exhausted?
Is there any obstacle between the
remote control and television?
Child lock is active.
-34-
Solution
Check the mains cable.
Check if the On/Off button is on.
Check the aerial cable.
Have the dish adjusted.
Try disconnecting one of the
devices.
Perform fine tuning.
Adjust Brightness, Contrast and
Colour.
Perform automatic, manual channel
setting or fine tuning.
Check aerial cable and system
Check the aerial cable.
Press the PR+ or PR- button to turn
on the TV.
Increase the colour.
Select the broadcast system.
Test with another channel.
Test another channel for fine tuning
and shadowy pictures
Check the antenna system.
Try pressing the mute button
Turn on the volume with Vol +
button.
Place the batteries correctly.
Replace the batteries with new
ones.
If yes, remove it.
Disable the child lock.