Page 1
All manuals and user guides at all-guides.com CONVERTIBLE TYPE AIR CONDITIONER Operation & Installation Manual...
Page 2
All manuals and user guides at all-guides.com Contents...
Page 3
All manuals and user guides at all-guides.com Cautions Disposal of the old air conditioner Safety Instructions and Warnings Disposal of the packaging of your new air conditioner...
Page 4
All manuals and user guides at all-guides.com Cautions Specifications Temperature and Humidity Range...
All manuals and user guides at all-guides.com Operation Tips Operation and Performance Accessories for installation *Heating Performance Optional parts Instructions relating to heating (*) are applicable only to "HEAT & COOL TYPE". *Microcomputer-controlled Automatic Defrosting...
All manuals and user guides at all-guides.com Installation of Indoor Unit WARNING ! Please call dealer to install the air-conditioner. CAUTION ! Air-conditioner can't be installed in the envi- Connect earthing wire. ronment with inflammable gases because the inflammable gases near to air-conditioner may cause fire hazard.
Page 14
All manuals and user guides at all-guides.com Installation of Indoor Unit WARNING 1 SELECTING THE MOUNTING POSITION WARNING CAUTION...
Page 15
All manuals and user guides at all-guides.com Installation of Indoor Unit Fig. 1 Fig. 2...
Page 16
All manuals and user guides at all-guides.com Installation of Indoor Unit Table 1 £¤EAA), INSTALLATION PROCEDURE 1. REMOVE THE INTAKE GRILL AND SIDE COVER 2. LOCATION OF CEILING SUSPENSION BOLTS Fig. 3 For half-concealed installation Fig. 4...
Page 17
All manuals and user guides at all-guides.com Installation of Indoor Unit 3. DRILLING THE HOLES AND ATTACHING THE SUAPENSION BOLTS ƒ ¡¡ Fig. 5 IF USING ANCHOR BOLTS Fig. 6 Special nut B (included) M10 Nut (Obtaied locally) M10 Nut (Obtaied locally) INSTALLING THE INDOOR UNIT...
Page 18
All manuals and user guides at all-guides.com Installation of Indoor Unit Fig. 7 Fig. 8 Ceiling Ceiling panel Wall Wall FOR HALF-CONCESLED INSTALLATION Fig. 9 CAUTION In order to check the drainage, be sure to use a level during installation of the indoor unit.
All manuals and user guides at all-guides.com Installation of Indoor Unit INSTALLING THE COUPLER HEAT INSULATION Fig. 10 Notice When installing the unit on the floor, fix the four rubber base feet in the accessories on the bottom plate of the unit with four 4x16 screws and 4 flat washers,as the position in the figure.
All manuals and user guides at all-guides.com Installation of Indoor Unit DRAIN PIPING Fig. 11 GOOD...
Page 21
All manuals and user guides at all-guides.com Installation of Indoor Unit Fig. 12 Fig. 13...
Page 22
All manuals and user guides at all-guides.com Installation of Indoor Unit ELECTRICAL WIRING HOW TO CONNECT WIRING TO THE TERMINALS A.For solid core wiring (or F-cable) B.For strand wiring Fig. 14 A. Solid wire B. Strand wire HOW TO FIXED CONNECTION CORD AND POWER CABLE AT THE CORD CLAMP...
All manuals and user guides at all-guides.com Installation of Indoor Unit ELECTRICAL REQUIREMENT Table 5 Fig. 15 Insulation tube Cord clamp Use VW-1, 0.5 to 1.0 mm thick, PVC tube as the insulation tube. CAUTION...
All manuals and user guides at all-guides.com Installation of Indoor Unit FRESH-AIR INTAKE Fig. 16 CAUTION Fig. 17 [After completing " INDOOR UNIT INSTALLATION"..] Fig. 18...
Page 25
All manuals and user guides at all-guides.com Installation of Indoor Unit Fig. 19 WARNING (1) Always use a special branch circuit and install a special receptacle to supply power to the room air conditioner. (2) Use a circuit breaker and receptacle matched to the capacity of the room air conditioner. (3) The circuit breaker is installed in the permanent wiring.
All manuals and user guides at all-guides.com Installation of Indoor Unit CAUTION (1) The power source capacity must be the sum of the room air conditioner current and the current of other electrical appliances. When the current contracted capacity is insufficient, change the contracted capacity.