Installation - Frigidaire FYD00226WC User Manual

Placement
WARNING!
Do not install the water dispenser in a
location where there is a direct impact
of sunlight or near heat sources, as a
stove, oven, etc
WARNING!
Do not plug in the device unless the
water bottle is already installed and
the system is full of water.
Use the appliance indoors, where is no
likelihood of rain or bad weather, as there is
damage risk to the product electrical
system.
The product must be installed in an easily
accessible location in case of repairs.
Put the appliance on a flat surface and
keep a minimum distance of 25 cm from
the wall. Make sure that the ventilation
openings of the product are not being
obstructed.
WARNING!
To avoid a hazard due to instability of
the appliance, it must be fixed in
accordance with the instructions.
1. Use 13 mm screw to fix the fixing
bracket on the middle of bottom cover.
2. Drill out a screw hole(6 mm) on the
floor.
3. Insert a screw anchor (wall plug) into
the drilled hole.
4. Move water dispenser, align fixing
bracket hole with screw hole of the floor
5. Put the 25mm screw into the screw hole
of fixing bracket.
6. Tighten the screw.
All fixing accessories are provided with
the appliance
3.9
mm
Installing the Water Bottle
Before putting the water bottle:
1. Make sure that the device is disconnect
from electricity.
2. Clean the inside of the water cooler,
where the water bottle is placed, with
warm water and mild detergent and
sterilize as indicated in Care and
cleaning section.
3. Clean and sterilize also the water bottle,
especially the part that will be inside the
water cooler.
4. Leave the protective plastic cap on the
bottle, where The product has a hole
punch.
5. Connect the device to electricity.
This product was developed to be used
with bottles of 10 or 20 litres.

INSTALLATION

4
mm
5