Bearing Installation; Rear Bearing Carrier Installation - Polaris GENERAL 2016 Service Manual

Table of Contents

BEARING INSTALLATION

1. Thoroughly clean the rear bearing carrier housing

and the outer race on the new bearing. Be sure that

all oil residue has been removed from each surface.

2. Support the bottom of the bearing carrier housing.

Use an arbor and press only on the outer race,

otherwise bearing damage may occur.

3. Apply Loctite

retaining compound to the outer

circumference of the new bearing race

carefully press the new bearing into the bearing

carrier housing

Use care to not allow any of the Loctite

get in the bearing.

4. Wipe the housing clean of any excess compound and

install the snap ring

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

1. Install drive shaft through the backside of the bearing

2. Install rear bearing carrier onto control arms and

mounting fasteners. Torque fasteners to specification.

Rear Bearing Carrier Mounting Fasteners:

3. Apply anti-seize to drive shaft splines.

4. Install rear wheel hub assembly

washer with domed side out

2016–2017 models have two cone washers

42 lb-ft (57 Nm)

, install cone

, and hand tighten the

Table of Contents