LG STYLER Owner's Manual page 15

Using Non-skid Pads
Non-skid pads prevent the appliance from shaking
or shifting when opening or closing the door.
1
Clean the floor to attach the non-skid pads.
• Use a dry rag to remove foreign objects or
moisture. If moisture remains, the non-skid
pads may slip.
2
Adjust the level after placing the appliance in
the installation area.
3
Place the adhesive side
pads on the floor.
4
Move the appliance feet onto the non-skid
pads.
• Do not attach the adhesive side
non-skid pads to the feet of the appliance.
5
Recheck the appliance's levelness.
• Push or rock the edges of the appliance
gently to make sure that the appliance does
not rock. If the appliance rocks, level the
appliance again.
NOTE
• The pads may leave a sticky residue when they
are removed. The residue can be removed with
alcohol.
Installing the Anti-tip Device
Install the anti-tip device packed with the
appliance to reduce the risk of tipping.
• Refer to the instructions provided with the anti-
tip kit for proper anti-tip device installation.
• Do not operate the appliance without the anti-tip
device in place and engaged.
• Check that the anti-tip device is properly
installed. With the appliance in its final location,
make sure that the slide adjuster on the cord is
of the non-skid
a
of the
a
adjusted until there is about 1 inch (2.5 cm) of
slack in the cord.
• If an anti-tip device is not properly installed, the
appliance could be unexpectedly tipped by a
child or adult standing, sitting, leaning, or
placing excessive weight on the open door or
the interior parts of the appliance.
• The use of the anti-tip device does not preclude
tipping of the appliance when it is not properly
installed.
Assembling the Drip Tray
Before using the appliance, insert the drip tray
onto the bottom of the cabinet.
1
Hold the tray so the arrow and letter on the
front of the tray face up.
2
Insert one side of the tray first, then the other.
Push the tray until it slides completely in.
3
To detach, pull one side out then the other.
• If the tray collects water, detach it and
empty the water. After emptying it,
reassemble the tray.
CAUTION
• Do not operate the appliance without installing
the drip tray. Doing so could lead to water
damage caused by leaking.
Installing Hinge Covers
1
Open the appliance door.
2
Snap a hinge cover onto the upper hinge
assembly with the bent edge on the far side
from the hinge.
INSTALLATION 15