LG STYLER Owner's Manual page 36

36 TROUBLESHOOTING
Problem
error message
Ps
shows on the display.
Operation
Problem
The appliance won't
operate.
The cycle won't start. Start/Pause button was not touched after the cycle was set.
Steam or hot air
comes out when the
door is opened
Full water supply
tank is empty after
just one use.
Appliance makes a
loud vibrating noise
on startup.
Styling times are
taking longer than
estimated.
Appliance is moving
from left to right
while operating.
Sound of motor
whirring.
Sound of water
running, boiling, or
hissing.
Steam or hot air
leaks out when the
door is closed.
Supply voltage is not correct.
• Please call LG service center. You can find your local LG service center phone number in
the warranty card.
Control panel has powered off due to inactivity.
• This is normal. Touch the Power button to turn the appliance on.
Cord is unplugged.
• Make sure cord is plugged securely into a working outlet.
Circuit breaker/fuse is tripped/blown.
• Check house circuit breakers/fuses. Replace fuses or reset breaker. The appliance should
be on a dedicated branch circuit.
Appliance is not connected to 120 V socket.
• Make sure the cord is plugged into a grounded socket rated for this appliance.
• Touch the Start/Pause button.
Cycle is producing steam.
• There may be a period of inactivity while steam is produced.
Control panel is locked.
• Disable the locking of the control panel and touch the Start/Pause button.
Door is opened during operation.
• It is normal for steam or hot air to escape if the door is opened during operation.
Appliance is being used for the first time.
• A larger amount of water is needed the first time the appliance is used to fill the empty
reservoir.
Moving hanger is balancing load before operation.
• This is normal at the beginning of the cycle. If the noise increases or continues for a long
time, call for service.
Clothes were extremely wet when loaded.
• Styling times may be longer for very wet or bulky clothing. Dry damp clothes before
putting them in the appliance. The appliance stops automatically when clothes are dry.
Floor under appliance is not level or is not sturdy enough to support the weight of the
appliance without flexing.
• Install the appliance where the floor is level and sturdy. Compensate for any slight
unevenness in the floor with the leveling legs.
Compressor is running during styling.
• This is normal.
Steam is being generated and sprayed onto clothes.
• This is normal.
An item is caught in the door, keeping it slightly open.
• Make sure all items are completely inside the cabinet and nothing is caught in the door,
blocking it from closing completely.
Possible Cause & Solution
Possible Cause & Solution