TYPE
MITSUBISHI Pressure Ventilator (for device cooling)
MODEL
Power supply
Three-phase 200-220 V
Blade type
35 cm metal propeller vane
Motor type
Totally enclosed 3-phase induction motor
(4-pole type A)
Temperature: –15℃ to +50℃
Relative humidity: 90% or less (normal
Ambient operating
conditions
temperature)
Indoor use
Load side: 6003DDW NC
Ball bearings
Reverse load side: 6003ZZ NC
Grease: Urea
Frequency
(Hz)
SPECIFICATIONS
50
IEC/EN 60335-1
IEC/EN 60335-2-80
IEC/EN 61000-6-1
Conforming
standard number
IEC/EN 61000-6-2
(IEC/EN)
IEC/EN 61000-6-3
IEC/EN 61000-6-4
UL 507
Conforming
standard number
UL 1004-1
(UL)
UL 1004-3
UL File No.
E474618
※ Air volume and power consumption are measured based on JIS C 9603.
The noise, power consumption and current are measured under free air condition
※
※ The value of the noise is at 1.5 m from the front and both sides of the appliance
in an anechoic room. (Average of the three points)
■Attention
※ Refer to the precautions on page 2.
■Drawings and Dimensions
■Connection Diagram
Dim. in
Third Angle
Projection Method
mm
MITSUBISHI ELECTRIC NAKATSUGAWA WORKS
EF-35UDT-GL
Air volume
Noise
(dB)
3
(m
/h)
3000
45-45.5
Household and similar electrical appliances-Safety-Part1 : General requirements
Household and similar electrical appliances-Safety-Part2-80 : Particular requirements for fans
Electromagnetic compatibility (EMC)-Part6-1 : Generic standards-Immunity for residential, commercial and
Electromagnetic compatibility (EMC)-Part6-2 : Generic standards-Immunity for industrial environments
Electromagnetic compatibility (EMC)-Part6-3 : Generic standards-Emission standard for residential, commercial
Electromagnetic compatibility (EMC)-Part6-4 : Generic standards-Emission standard for industrial environments
Standard for Electric Fans
Standard for Rotating Electric Machines - General Requirements
Standard for Thermally Protected Motors
Scale
Date
Non proportional
Sep 2017
Withstand voltage
Insulation resistance
Weight
Color
Material
Power
Current
consumption
(A)
(W)
130-145
0.85-1
light-industrial environments
and light-industrial environments
※This appliance is only for exhaust-use.
※The nominal output is only a rough estimate. When
.
selecting a breaker or an overload protection device,
select it according to the maximum load current
value. (Refer to page 2 for details.)
■Characteristics
200V
220V
※ The air volume was measured using the orifice
chamber method.
MITSUBISHI Pressure Ventilator (for device cooling)
Model
Number
NJ215016B-50 (1/2)
VOLUME
SIGN
2000 V AC 1 minute
10 MΩ or more
(with 500 V Insulation resistance tester)
9.2 kg
Munsell: 7.65Y7.6/0.7
Body frame, Vane, Motor leg, Motor cover:
Polyester coating
Vane: Steel sheet
Motor leg: Flat bar
Body frame, Motor, Motor cover:
Galvanized sheet steel
Maximum
Starting
load current
current
(A)
(A)
0.98-1.06
5.37-6.01
EF-35UDT-GL
Specification
Nominal
output
(W)
150