Panasonic KX-HNC600C Installation Manual page 18

Setup
Ideal example
Structure supports exterior surface
Siding
1
Structure behind siding
2
Concrete
R Do not use the included screws. Use screw
anchors (screw ø: 4 mm (5/32 inches))
designed for concrete walls.
R Carefully read the instructions supplied with
the anchors. Follow instructions regarding
drill bit diameter, hole depth, etc.
R Drill a pilot hole. Remove any debris after
drilling the pilot hole.
1
Mark the hole depth on the drill bit (
and then drill a pilot hole.
1
2
Remove debris.
3
Insert an anchor, tighten the screw, then
remove the screw to secure the anchor.
For assistance, visit www.panasonic.ca/english/support
18
HNC600C_(en_en)_0113_ver.201.pdf
4
Insert the screw and tighten it.
2
2
ALC (autoclaved lightweight cellular
concrete)
R Depending on the type of ALC panel, you
1
may not be able to attach the camera.
Consult the ALC panel manufacturer.
R Do not use the included screws. After
consulting the manufacturer of the ALC
panel, use only commercially-available
metal screw anchors (screw ø: 4 mm
(5/32 inches)) designed for ALC panels.
R Carefully read the instructions supplied with
the anchors. Follow instructions regarding
drill bit diameter, hole depth, etc.
R Drill a pilot hole. Remove any debris after
drilling the pilot hole.
R Seal the pilot hole with a
commercially-available waterproof sealant.
)
1
Other materials (mortar, tile, etc.)
R Do not use the included screws.
R Consult the builder or licenced professional
regarding the type of anchor appropriate for
the installation location and materials.
R Do not install on gypsum board or concrete
blocks.
18
2
Camera mounting stand
2017/01/13 11:54:13