Interface Connectors - D-Link Nuclias Connect Hub Plus DNH-200 Quick Installation Manual

Interface Connectors

1 2
Figure 2: Front Connectors
# Connector
Console RJ-45 port to connect the RJ-45
1
Port console cable for CLI management.
Ethernet Gigabit RJ-45 por t for LAN
2
Port connection.
USB 2.0 supports flash drive for
3 USB Port video export and configuration
backup.
Device Reboot
Press the Reset button once to
reboot device
Reset to Factory Default
Hold the Reset button for 5
seconds, then all LEDs will light on
at the same time. After 1 second,
4 Reset all the LEDs will light off then the
device will reboot and back to
factory default
Recovery
Press and hold the Reset button
and then turn on the power of the
device. It will enter Recovery Mode
for a firmware recovery process
Table 2: Interface Description
DNH-200 Quick Installation Guide
3 4
Description
Configuration
Note: D-Link recommends manually configure
the device before mounting it. The management
computer, DHCP server and DNH-200 must be
in the same network.
Connecting through Ethernet
You need the following equipments to access
the web interface of your device:
• A PC with a RJ-45 Ethernet connection
• A Ethernet cable
• A power adapter
1. Pull out the hard disk tray from
the DNH-200 device.
2. Insert a 2.5-inch hard disk into the tray
and secure the HDD with the supplied
screws.
Figure 3
Figure 4
3