Terminal Description; Terminal Connections; Pin Functions - Epson RX-8564LC Applications Manual

RX 8564 LC

3. Terminal description

3.1. Terminal connections

3.2. Pin Functions

Signal
I/O
name
SCL Input
SDA Bi-Directional
CLKOUT Output
CLKOE Input
/INT Output
V
DD
GND
N.C.
Note : Be sure to connect a bypass capacitor rated at least 0.1 µF between V
RX
1.
N.C.
2.
N.C.
# 1
3.
N.C.
4.
N.C.
# 6
5. /INT
6. GND
VSOJ 12pin
This is the serial clock input pin for I
This pin's signal is used for input and output of address, data, and ACK bits,
synchronized with the serial clock used for I
Since the SDA pin is an N-ch open drain pin during output, be sure to connect a suitable
pull-up resistance relative to the signal line capacity.
The CLKOUT pin is a clock output pin (C-MOS output) with the output control function.
The CLKOE pin can be used in combination with the FE bit, FD1 bit, and FD0 bit to
control the output mode of the CLKOUT output pin.
The CLKOE input pin can be used in combination with the FE bit, FD1 bit, and FD0 bit to
select the frequency output from the CLKOUT output pin (32.768 kHz, 1024 Hz, 32 Hz, or
1 Hz) or to stop output.
When output is stopped, the CLKOUT output pin is at low level ( = " L " ).
CLKOE pin FE
input bit
1
" H "
0
1
" L "
0
During the initial power-on (when power is applied from 0 V), if the CLKOE input pin is at
high level ( = " H " ), the power-on reset function selects 32.768 kHz as the frequency.
This pin outputs alarm signals, fixed timer interrupt signals, and other interrupt signals at
low level ( = " L " ). This pin is an open drain pin.
This pin connects to the plus side of the power.
This pin connects to the minus side (ground) of the power.
This pin is not connected internally. Be sure to connect using OPEN, or GND or VDD.
Page
8564 LC
12.
N.C.
11. CLKOE
# 12
10. V
DD
9. CLKOUT
# 7
8. SCL
7. SDA
Function
2
C Bus communications.
2
C communications.
CLKOUT pin
output
Output
( C-MOS )
OFF
( " L " )
OFF
( " L " )
OFF
( " L " )
and GND.
DD
2 ETM12E-01