Yamaha ARIUS YDP-165 Owner's Manual page 39

6.
(YDP-S55 only) With the non-felt
side of the front board facing the
front (pedal side), fix it with thin
screws (4 × 12 mm).
Install so that the gap between the side boards (L)
and (R) is equal on both sides.
Main unit
Side
Front board
board
(L)
Back board
Front board back side
7.
Connect the pedal cord plug and the
power plug.
7-4
DC IN
7-2
Cord
holder
7-1
Insert the pedal cord plug to the
[TO PEDAL] jack from the rear.
Insert the plug until the metal part disappears
from view.
Thin screws (4 × 12 mm)
× 2
Side
board
(R)
Felt
7-1
TO PEDAL
Metal part
NOTICE
If it is not plugged in firmly, it may cause the pedals to
not work.
7-2
Wind the cord holder around pedal cord to
hold it.
The cord holder is attached to the side board (L).
7-3
(YDP-S55 only) Connect the power cord to
the AC adaptor.
7-4
Insert the DC plug into the DC IN jack.
8.
Rotate the adjuster until it presses in
firm contact with the floor surface.
Make sure that the pedal box does not rattle or
give way when you step on the pedals.
To press against
the floor
YDP-165, YDP-145, YDP-S55, YDP-S35 Owner's Manual
Keyboard Stand Assembly
To separate from
the floor
39