Advertisement
Install the Device/ 设备安装
D Indoor Ceiling-Mount/ 室内吊装
1
Place the wall-mount bracket to
the installation position, and use
the marker to mark the locations
of installation holes, and install
the expansion bolts into the holes.
Re m o ve t h e f l a t w a s h e r, s p r i n g
washer, and nuts.
使用记号笔绘制螺钉安装位置，并根据绘
制的螺钉安装位置钻孔。 使用羊角锤将
膨胀螺栓打入钻好的孔内。再将平垫、弹
垫和螺母拧下。
E Pole-Mount/ 立杆抱装
1
Install the wall-mount bracket to the pole-mount bracket.
将壁装支架安装到抱装支架上。
2
Use loops to install the pole-mount bracket to the pole.
使用抱箍将抱装支架安装到柱杆上。
2
Install the ceiling-mount bracket.
安装吊装支架。
3
Unfasten the screws on the universal joint to enable the universal
joint to rotate freely. Fix the shield on the universal joint, adjust the
shield position, and tighten the screws on the universal joint.
拧松万向节上的螺钉，使得万向节可以自由转动。将护罩固定到万向节上，
调整好护罩方位后，拧紧万向节上的螺钉。
3
Fix the box camera to the ceiling-mount bracket.
将枪机固定到吊装支架上。
F Beam-Mount/ 横臂抱装
1
Use a hold hoop to install the pole-mount bracket on the cross arm
(refer to step 2 in E Pole-Mount), install the universal joint into No.2
hole on the pole-mount bracket, as shown in the following figure
(properly adjust the horizontal monitoring angle during installation).
使用抱箍将抱装支架安装到横臂上（参见"立杆包装中的步骤 2），然后将
万向节安装到包装支架 2 号孔位 （如下图， 安装时注意调整好水平监控角度） 。
2
Unfasten the screws on the universal joint to enable the universal
joint to rotate freely. Fix the shield on the universal joint, adjust the
vertical monitoring angle, and tighten all screws on the universal
joint.
拧松万向节上的螺钉，使得万向节可以自由转动。将护罩固定到万向节上，
调整好垂直监控角度，拧紧万向节上的所有螺钉。
Advertisement
