Fault Codes; Removing Collected Water - Frigidaire 2020266A0107 Use And Care Manual

Operating Instructions

Fault Codes

1. If the display reads "AS" or "ES" , a sensor has failed. Contact your Authorized Frigidaire Service Center.

Removing Collected Water

1. Emptying the Bucket:
a. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate.
b. Do not move the unit at this point otherwise water may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from the unit.
d. Remove the bucket as shown in the photographs below and empty the bucket.
WARNING
Discard water from bucket. Water is not potable and cannot be used for drinking.
e. Replace the empty bucket back into the unit and once seated correctly the unit will start up again.
f. You should hear a click when the bucket is in the correct position
2009 Electrolux Home Products, Inc.
6
All rights reserved.