Hitachi CP-X960WA Service Manual page 29

DC FAN (INTAKE)
THERMISTER
Pass the 2 cables through the
cable cutout in the front panel
duct cover.
DC FAN (POWER)
Optical Unit Wiring
Pass through the Optical Unit gap,
using care to avoid pinching.
to POWER UNIT
(BALLAST)
DC MOTOR ASS'Y
CNPWR
slack
CN102
Don't stretch the CNPOW cable.
Slacken off like an above
drawing.
BOTTOM
TOP
Set Bottom Wiring
CNFAN must extend beyond
the projection lens.
Don't pass through the Power
Supply PWB holder cutout.
Position close
to the projection
lens rib.
CN101
the lens rib
TAPE1
CNFAN
Wire from the
boss to the
Signal PWB.
POWER UNIT
(CURCUIT)
Fasten with tape.
SPEAKER (L)
Fasten by engaging the
wiring between the Circuit
Power Supply PWB and
Filter PWB on the tab on
the bottom case.
After fastening cables, push the
loop in the dirrection of arrow.
Cabinet wiring clamp
Adjustment foot screw
Keep the twisted loop away
PWB SIGNAL from the adjustment foot screw.
Twist to the left 1- 2 turns and then install
CNVID
the Video PWB in the chassis.
ESV1
EVS1
PWB VIDEO
EPOW
CNPOW
Use caution to avoid crushing I 206
Allow no slack.
when installing the Optical Unit.
ESD1
OK
Pass beneath
the Signal PWB.
CNDS1
Boss
E4R E4L EFAN
CNSG
Place tape on the sharp
edges of the AC metal
and AC sheet.
Wind the Speaker L lead And bend tape to the
once around Cabinet wiring backside.
clamp.
PWB/RC
CN1A
PWB FILTER
CNRM
to LSW1
SPEAKER (R)
to PWB MAIN
Leave outside until the
Optical Unit is positioned.
Use caution attaching the
polarity.
OK NG
to PWB MAIN
Leave outside until the
Optical Unit is positioned.
to PWB MAIN
BOTTOM
TOP