Table of Contents
Advertisement
Short Form
65
67
68
69
70
76
77
85
86
Yn - Long Space Disconnect
This command controls the generation and response to long space disconnect.
Y0
Disables long space disconnect (default)
Y1
Enables long space disconnect
Zn - Reset
This command will force the modem to perform a soft reset. If nonvolatile memory is supported it will
restore the profile according to the parameter of the command.
Z0
Reset and restore stored profile 0
Z1
Reset and restore stored profile 1
&Cn - DCD (Data Carrier Detect) Option
This command informs the modem how to control DCD signal (V.24 circuit 109).
&C0
DCD remains ON at all times
&C1
DCD follows the state of the carrier (default)
&Dn - DTR (Data Terminal Ready) Option
This command informs the modem how to treat DTR signal (V.24 circuit 108).
&D0
The modem ignores DTR signal. (default)
&D1
In on-line data mode DTR transition from ON to OFF forces The modem to go into on-line
command mode (same as escape sequence).
&D2
The modem hangs up on DTR transition from ON to OFF.
&D3
The modem performs soft reset on DTR transition from ON to OFF.
&Fn - Restore Default Configuration.
The modem restores the default ( "factory" ) configuration.
&F0
Restore default configuration
&F1
Restore default configuration
Note: The modem has only one default configuration.
42
Long Form
CARRIER 33600
COMPRESSION: V.42bis
CONNECT 31200
COMPRESSION: NONE
CONNECT 33600
PROTOCOL: NONE
PROTOCOL: LAPM
RRING
NO BONGTONE
n - Value in ATXn Command
0
1
2
Y
Y
Y
Y
Y
Y
1
Y
Y
Y
Y
Y
1
Y
Y
Y
Y
Y
Y
Y
Y
N/A
N/A
N/A
N/A
N/A
N/A
3
4
5
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
N/A
N/A
Y
N/A
N/A
Y
Advertisement
Table of Contents
