Mitsubishi Electric Lossnay LGH-50RVS-E Handbook page 41

( 5 ) Terminal block parts
[1] Remove the control box cover. → See (2) [1].
[2] Check that LED4 on the control circuit board is OFF,
and then disconnect the connectors (indicated by
from the control circuit board.
[3] Remove the screw (one PPT screw 4×25, indicated by
).
[4] Remove the screws (three PT screws 4×8, indicated by
[5] Disconnect the connectors (indicated by
power circuit board and the reactor, and remove the
terminal brock with the lead wires.
Side plate
) from the
Terminal block
)
Control circuit board
), and remove the sub control base.
Control base
Sub control base
─ 41 ─
CN7
CN19
CN5
CN14
Sub control base
Control base
Power circuit board
TAB2
TAB1
Reactor Terminal brock