The date is set.
Volume
The volume for various sounds can be changed.
The volume can be changed for the following tones:
Finish tone
-
The finish tone signals the end of the drying program.
Keypad tone
-
Welcome tone
-
Fault alarm
-
The fault tone signals a fault and can be switched off. The volume of the fault tone can-
not be adjusted.
Res. moisture display
In addition to displaying the drying level, the residual moisture can also be indicated as a
percentage.
Without % value
- Factory default:
With % value
-
Visibility parameters
Various parameters are offered/displayed when a program is selected. You can decide
which parameters should not be displayed. These parameters can then not be edited dur-
ing program selection.
-
Residual moisture
Duration
-
Low temperature
-
Anti-crease
-
-
Load size
Drying temperature
-
Display off status
The display switches off to save energy; only the Start/Stop sensor control flashes slowly.
You can change this setting.
Changing this setting leads to increased energy consumption.
-
Off
No switching off
On (10 min.) Not curr.prog.
-
The display will remain on while the program is running but will go out 10 minutes after
the end of the program.
-
Logo (10 min.) Not curr.prog.
The display will remain on while the program is running but the logo will light up 10 min-
utes after the end of the program.
Supervisor level
39